Optimization and Research on Hydraulic Control System Of Machining Equipment Worktable

Main Article Content

Shengwei SUN

Abstract

In order to solve the problem of precise positioning at micron level, a hydraulic system using servo motor and displacement amplifier hydraulic cylinder instead of servo valve is proposed. The simulation results show that the open-loop response speed of the system can be improved by increasing the elastic modulus of the oil and reducing the viscosity of the oil, while the pressure and volume of the accumulator have no obvious influence on the open-loop performance of the system. The micro displacement control hydraulic system is applied to the integrated test-bed, and PD controller is selected as the position controller according to the identification results. The validity and feasibility of the micro displacement control hydraulic system are verified.

Downloads

Download data is not yet available.

Article Details

Section
Articles
Author Biography

Shengwei SUN, Shengwei SUN Binzhou University Binzhou, China

Binzhou University

Binzhou, China

References

F. Xijing. “AMESim simulation technology and its application in hydraulic system,†Hydraulic Pneumatic and Sealing, vol.32, pp.206-209, October 2015.

L. Liu-min, H. Guiyun. “Research status and development trend of hydraulic system fault diagnosis technology,†Computer Simulation, vol.33, pp. 234-237, August 2016.

L. Hongsheng. “Development and research status of hydraulic free piston engine,†Journal of Mechanical Engineering, vol. 31, pp. 407-411, January 2014.

L. Qiaohua. “Hydraulic energy system of large airliner,†Journal of Automotive Engineering, vol. 01, pp. 464-468, April 2014.

Q. Canwen. “theoretical analysis of flow pulsation of axial piston pump,†Lubrication and Sealing, vol.3, pp. 45-47, June 2018.

Z. Zhiguo, P. Yugang. “Inverted pendulum control system based on PID neural network,†Mechanical Design and Manufacturing, vol.24, pp.208-215, July 2015.

W. Kesheng, Z. Leiqiang. “Dynamic simulation of hydraulic system based on Simulink,†Computer Simulation, vol.28, pp.342-347, April 2013.